Professional Epoxy Flake Flooring Services in Singapore

Epoxy flakes flooring is a multi-layer coating system in which decorative vinyl flakes are broadcast into an epoxy base coat and sealed with a protective topcoat. It creates a seamless, textured and durable finish.

Epoxy flake flooring can be installed in garages, warehouses, factories, workshops, retail shops, showrooms, offices, commercial kitchens, and car parks. It works in both residential and commercial settings. The main requirement is a structurally sound concrete substrate. Surfaces with excessive moisture or severe structural damage need to be assessed and addressed first.

A properly installed epoxy flake floor typically lasts between five and ten years in residential settings and three to seven years in heavy commercial or industrial environments. Longevity depends on surface preparation quality, the products used, traffic levels, and how the floor is maintained. Regular cleaning and avoiding harsh chemicals extend the floor's service life noticeably.

Epoxy flake flooring is not slippery in normal conditions. The broadcast flakes create a textured surface that provides grip underfoot. In wet areas or environments where spills are common, additional anti-slip agents can be added to the topcoat for extra safety. This makes the system a suitable choice for garages, commercial kitchens, and other areas prone to moisture.

Most standard installations are completed in one to two days, depending on the floor size and condition. Surface preparation usually takes the most time. After the final topcoat is applied, the floor needs to cure before it can be walked on, typically 24 hours for light foot traffic and 48 to 72 hours before heavy use or vehicle access.

Yes, epoxy flake flooring is applied directly over existing concrete in most cases. The concrete must be mechanically prepared - usually by diamond grinding - to remove any contamination and create a surface the epoxy can bond to. Existing failed coatings, sealers, or paint must be removed first. Cracks and damaged areas are repaired before the coating system is applied.

Yes, epoxy flake flooring is applied directly over existing concrete in most cases. The concrete must be mechanically prepared - usually by diamond grinding - to remove any contamination and create a surface the epoxy can bond to. Existing failed coatings, sealers, or paint must be removed first. Cracks and damaged areas are repaired before the coating system is applied.

Routine maintenance is straightforward. Sweep or vacuum regularly to remove loose debris, then mop with warm water and a mild pH-neutral cleaner. Avoid strong solvents or highly alkaline cleaning agents, which can break down the topcoat over time. Placing mats at entry points reduces the amount of grit tracked in, which is the most common source of surface wear.

The polyurethane or epoxy topcoat used in a flake system provides good resistance to oils, fuels, mild acids, cleaning agents, and common workshop chemicals. Spills should still be cleaned up promptly rather than left to sit. Very strong chemicals or solvents in high concentrations can damage any coating over time. For facilities handling aggressive chemicals, we can advise on suitable topcoat options during the site assessment.

Epoxy flake flooring cost in Singapore varies depending on the floor area, current concrete condition, chosen flake density and colour blend, and whether additional preparation work - such as crack repairs or levelling - is needed. There is no single price per square metre that applies to every project. The most accurate way to get a fair price is to request a site assessment and itemised quotation based on your actual floor.

A professional epoxy flake flooring contractor has the equipment, materials, and experience to prepare the surface correctly and apply the coating in the right conditions. Improper preparation is the most common reason coatings fail early. A professional also understands how Singapore's humidity affects application timing, curing, and long-term adhesion. DIY kits and inexperienced applicators often produce results that look acceptable at first but fail within months, requiring the floor to be stripped and redone at additional cost.